AC GATE EDGE RADIO KIT MONITORED
UL325 2016 approved for APeX2 operators
The SGEKAC kit includes one SGET transmitter, one SGER receiver, and one SGACsens sensor.
In a typical
installation, the SGET is mounted on a motorized gate, door or barrier arm and wired
to a 10K exterior safety edge sensor which presents a closed circuit across the
connecting wires when an object is hit during the closing of a gate.
To insure full compatibility with all gate edge supervision features, NSC recommends
Miller gate edge sensors with 10K only. Please specify when ordering sensor.
The SGER is a wireless radio control designed for use
with automatic gate openers or garage door operators. The radio format provides
unparalleled security. Receivers and transmitters do not contain a typical "coding
switch". Each transmitter is pre-set at the factory to a unique code. The receiver
is programmed by sending a signal to it from the transmitter(s) that are going to
be used with it. This stores the transmitters code into the receiver's memory. The
receiver will retain its memory even without power. The receiver will activate only
from these "memorized" transmitters.
The receivers can operate from 10.5-30 volts DC and are normally powered from
the gate operator. The relay contact(s) are rated at 5 amps @ 32 volts AC/DC NEC
Class 2 circuit.
The AC Sensor is capable of reliably sensing AC motor activation by being in close proximity but not electrically connected to an active motor feed wire.